Removing An Ssd Carrier - IBM PS703 Service Manual

5. Locate the connector for the drive.
6. Place the drive 1 into the drive tray and push it toward the rear of the blade, into the connector
until the drive moves past the lever at the front of the tray.
Attention: Do not press on the top of the drive. Pressing the top might damage the drive.
7. Install and close the blade server cover. See "Installing and closing the blade server cover" on page
235.
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the power source. Always
replace the blade server cover before installing the blade server.
8. Install the blade server into the BladeCenter unit. See "Installing the blade server in a BladeCenter
unit" on page 232.

Removing an SSD carrier

You can remove an SSD carrier from a PS703 blade server, or from either the base unit or the expansion
unit of a PS704blade server.
Figure 30. Removing an SSD carrier
Perform the following procedure to remove the drive.
244
Power Systems: Problem Determination and Service Guide for the IBM PS703 (7891-73X) and PS704 (7891-74X)