IBM PS703 Service Manual page 79

Table 18. BA000010 to BA400002 Partition firmware SRCs (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved. If an action solves the problem, then you can stop performing the remaining actions.
v See Chapter 3, "Parts listing, type 7891," on page 225 to determine which components are CRUs and which
components are FRUs.
Error code
BA01000D
BA01000E
BA01000F
BA010010
BA010011
BA010013
BA010014
BA010015
Description
The iname parameter string exceeds the
maximum length allowed.
The LUN specified is not valid.
The chapid parameter string exceeds the
maximum length allowed.
The chappw parameter string exceeds
the maximum length allowed.
SET-ROOT-PROP could not find / (root)
package
The information in the error log entry
for this SRC provides network trace
data.
The information in the error log entry
for this SRC provides network trace
data.
The information in the error log entry
for this SRC provides network trace
data.
Action
The embedded host Ethernet adapters (HEAs)
help provide iSCSI, which is supported by
iSCSI software device drivers on either AIX or
Linux. Verify that all of the iSCSI configuration
arguments on the operating system comply
with the configuration for the iSCSI Host Bus
Adapter (HBA), which is the iSCSI initiator.
The embedded host Ethernet adapters (HEAs)
help provide iSCSI, which is supported by
iSCSI software device drivers on either AIX or
Linux. Verify that all of the iSCSI configuration
arguments on the operating system comply
with the configuration for the iSCSI Host Bus
Adapter (HBA), which is the iSCSI initiator.
The embedded host Ethernet adapters (HEAs)
help provide iSCSI, which is supported by
iSCSI software device drivers on either AIX or
Linux. Verify that all of the iSCSI configuration
arguments on the operating system comply
with the configuration for the iSCSI Host Bus
Adapter (HBA), which is the iSCSI initiator.
The embedded host Ethernet adapters (HEAs)
help provide iSCSI, which is supported by
iSCSI software device drivers on either AIX or
Linux. Verify that all of the iSCSI configuration
arguments on the operating system comply
with the configuration for the iSCSI Host Bus
Adapter (HBA), which is the iSCSI initiator.
1. Reboot the blade server.
2. If the problem persists:
a. Go to "Checkout procedure" on page
176.
b. Replace the system-board, as described
in "Replacing the FRU system-board
and chassis assembly" on page 264.
Informational message. No action is required.
Informational message. No action is required.
Informational message. No action is required.
Chapter 2. Diagnostics
67