IBM PS703 Service Manual page 162

Table 27. 101-711 through FFC-725 SRNs (continued)
SRN FFC
25C4-xxx 25C4
25C4-201 25C4
25C4-701 25C4
25C4-601 25C4
25C4-602 25C4
2604-xxx 2604
2604-102 2604
2604-103 2604
2604-104 2604
2604-105 2604
2604-106 2604
2604-108 2604 221
2604-110 2604
2604-201 2604 221
2604-203 2604
2604-204 2604 221
2604-205 2604 221
2604-701 2604
2604-703 2604
2604-704 2604
2604-705 2604
2604-706 2604
150
Power Systems: Problem Determination and Service Guide for the IBM PS703 (7891-73X) and PS704 (7891-74X)
Description and Action
Generic reference for Broadcom adapter. Go to "Performing the checkout procedure"
on page 177.
Configuration error. Go to "Performing the checkout procedure" on page 177.
Permanent adapter failure. Go to "Performing the checkout procedure" on page 177.
Download firmware error. Go to "Performing the checkout procedure" on page 177.
EEPROM read error. Go to "Performing the checkout procedure" on page 177.
Generic reference for 4Gb Fibre Channel Adapter card. Go to "Performing the checkout
procedure" on page 177.
Reset Test failure for the Fibre Channel adapter card. Replace the 4Gb Fibre Channel
Adapter card.
Register Test failure for the Fibre Channel adapter card. Replace the 4Gb Fibre Channel
Adapter card.
SRAM Test failure for the Fibre Channel adapter card. Replace the 4Gb Fibre Channel
Adapter card.
Internal Wrap Test failure for the Fibre Channel adapter card. Replace the 4Gb Fibre
Channel Adapter card.
Gigabit Link Module (GLM) Wrap Test failure for the Fibre Channel adapter card.
Replace the 4Gb Fibre Channel Adapter card.
Enhanced Error Handling Failure on the bus for the Fibre Channel adapter card. Go to
"Performing the checkout procedure" on page 177.
Enhanced Error Handling Failure on the Fibre Channel adapter card. Replace the 4Gb
Fibre Channel Adapter card.
Configuration Register Test Failure for the Fibre Channel adapter card. Go to
"Performing the checkout procedure" on page 177.
PCI Wrap Test Failure for the Fibre Channel adapter card. Replace the 4Gb Fibre
Channel Adapter card.
DMA Test Failure for the Fibre Channel adapter card. Go to "Performing the checkout
procedure" on page 177.
Error on Read/Write Operation for the Fibre Channel adapter card. Go to "Performing
the checkout procedure" on page 177.
Error Log Analysis indicates that the adapter self-test failed for the Fibre Channel
adapter card. Go to "Performing the checkout procedure" on page 177.
Error Log Analysis indicates that an unknown adapter error has occurred for the Fibre
Channel adapter card. Go to "Performing the checkout procedure" on page 177.
Error Log Analysis indicates that an adapter error has occurred for the Fibre Channel
adapter card. Go to "Performing the checkout procedure" on page 177.
Error Log Analysis indicates that a parity error has been detected for the Fibre Channel
adapter card.
The adapter must be replaced immediately. Failure to do so could result in data being
read or written incorrectly.
Error Log Analysis indicates that a fatal hardware error has occurred for the Fibre
Channel adapter card.
This adapter was successfully taken off-line. It will remain off-line until reconfigured or
the system is rebooted. This adapter must be replaced and not brought back on-line.
Failure to adhere to this action could result in data being read or written incorrectly or
in the loss of data.