Eclipse 16 - Teletek electronics ECLIPSE 8 Installation Manual

Eclipse 8/16/32/99 Series - Installation Manual

2.2.2 ECLIPSE 16

ECLIPSE 16 - Terminals and components:
17VAC – Power supply from a mains transformer 17V/23VA, fuse 0.63А
– Grounding
+/- AUX – Power supply for detectors with consumption up to 0.5А
+PGM – Power supply of auxiliary devices with consumption up to 0.5А
PGM 1-4 – Programmable outputs, 100mA, ОС type (open collector)
PGM 5/SIREN – Programmable output, high power up to 1А, ОС type (open collector), for connecting siren
Z1-Z16 – Zone inputs
COM – Common ground for the zones
R(red), G(green), Y(yellow), B(black) - System bus interface for connection of keyboards, proximity card readers, expanders,
etc.
Jumper RESET – Jumper for total hardware reset of the control panel
Serial – PC Interface connection
Service KBD – Connecting a service keyboard - see also item 6 (available for HW 1.1 and higher)
VOICE - Interface connector for mounting of Voice module ECLIPSE VD
BATT – Terminals for connecting the back-up battery
USB – Micro USB port for programming with ProsTE software (available for HW 1.5 and higher)
PSTN terminals:
TIP1, RING1 – Connect the telephone device
TIP, RING – Connect the PSTN line
– Grounding
Fuses, PTC type:
F1 – Fuse for the back-up battery: 0.75A
F2 – Fuse for PGM outputs: 0.5A
F3 – Fuse for AUX outputs: 0.5A
LED indication:
•
PSTN LED – LED for the status of the built-in digital communicator.
•
BUS LED – LED for the status of the system bus:
BUS LED
RESET Jumper is set; Problem with the system bus;
Red
no communication
Orange Short circuit of the system bus
Green Selected device of the system bus
Figure 6. ECLIPSE 16 control panel
Lights on permanently
Low power supply
Wrong connection of the system bus
Normal operation mode
10
Blinks in pulses