Setting A Reference Unit By Entering Known Piece Mass; Setting A Reference Unit By Weighing A Sample - RADWAG WPY series User Manual

• The weight unit is automatically changed to „pcs" and two screen
buttons on the right side appear:

24.2. Setting a reference unit by entering known piece mass

Procedure:
• Enter mode <
of this manual,
• Press
<Reference Unit> with the screen keyboard,
• Enter a value and confirm it by pressing
Counting Pieces> with automatic setting the reference unit.
<
Notice:
1. In case of entering a reference unit higher then the maximum weighing
range of the main scale the program will display a message box:
<Value too high>,
2. In case of entering the single piece mass lower than 0.1 d, the program
will display a message box: <Value to small>.

24.3. Setting a reference unit by weighing a sample

Procedure:
• Enter mode <
of this manual,
• If pieces are weighed in a container it needs to be put on the pan
and tarred,
• Press
<Reference Quantity> together with the screen keyboard,
Enter piece mass
Estimate piece mass
Counting Pieces> according to ch. 24.1
(enter piece mass), then an editing field is displayed
Counting Pieces> according to ch. 24.1
(estimate piece mass), then the editing field is displayed
, which causes starting
74