Configuration Of Outputs - RADWAG WPY series User Manual

18.2. Configuration of outputs

Ascribing a function to the output enables the output at the same time.
If an output has no ascribed function it is disabled.
Procedure:
• Enter <
• Choose <
will see the list of functions:
None
Stabile
MIN stable
MIN non-stable
OK stable
OK non-stable
MAX stable
MAX non-stable
Confirmation of
cycle completion *
*) Not applicable to „Comparator" software.
• Choose the required function from the list and return to weighing saving
the changes according to ch. 12.2 of this manual.
Notice:
By default all outputs have no function attributed – setting <None>.
Inputs / Outputs> according to ch. 18 of this manual,
Outputs> and enter the required output, then you
Output disabled
Stable weighing result over LO threshold value
Stable weighing result below the MIN threshold
Non-stable weighing result below the MIN threshold
Stable weighing result between MIN and MAX
thresholds
Non-stable weighing result between MIN and MAX
thresholds
Stable weighing result over the MAX threshold
Non-stable weighing result over the MAX threshold
Signal that confirms that a cycle of dosing has been
completed (the defined amount)
53