Selecting The Series Type; Declaration Of The Number Of Measurement Series - RADWAG WPY series User Manual

• Choose „
and then set an appropriate value.
Accessible settings: 1 d, 2 d, 5 d, 10 d.
Notice:
While the procedure of evaluation the mass of single piece the the mass
of all pieces put on the pan is lower than the value declared in parameter
„ Minimum reference mass", the following warning message will
be displayed: < Too low sample mass>.

22.9. Selecting the series type

Procedure:
• Enter group of parameters <
to ch. 22 of this manual: „
and then choose the right method.
Accessible methods:
• ABBA
• ABA

22.10. Declaration of the number of measurement series

Procedure:
• Enter group of parameters <
to ch. 22 of this manual,
• Choose: „
then an editing field will appeare < Number of measurements>
with the screen keyboard,
• Inscribe the required value and confirm it by pressing
Counting pieces /
Comparator /
Minimum reference mass"
It concerns the <
Working modes> according
Comparator /
It concerns the <
Working modes> according
Number of measurements"
72
Comparator> working mode
Method"
Comparator> working mode
.