Christie Roadie HD+35K Setup Manual page 22

Section 2: Installation and Setup
4. Lock the lens assembly in place with the lens clamp DOWN.
5. For added security, tether the lens to the projector by wrapping it around
either the handle or FredFrame™ if flown. This step is not required if the
projector is floor-mounted.
6. Remove the front lens cap.
7. Calibrate the lens. See
Operation in the Roadie HD+35K User Manual.
To calibrate the lens, select the Configuration > Diagnostics and Calibration > ILS Calibration > Reference
Calibration option from the Main menu. This allows the lens to find the center points of each axis (focus,
zoom, horizontal, and vertical), the end stops, and other motion parameters.
Failure to calibrate the lens can cause damage to the lens mount.
NOTE:
Lens Center Command
This command moves the lens horizontal and vertical motion to the center of travel.
The lens seals the projection head, preventing contaminants from entering the area of main electronics.
NOTES: 1)
Never attempt to operate the projector without a lens installed. During transport and installation, install a
lens plug.
adjustment.
2-12
In the event a lens is dropped, the lens tether and clamp
assembly may become stressed, and therefore must be
replaced before continuing its use. Failure to do so could
result in injury or death.
Figure 2-14. For more information, refer to Section 3,
Lens calibration must be performed each time a new lens is inserted or after
performing manual lens mount adjustments. This is critical to the projector
functioning properly. Failure to do so could result in damage to the lens mount, the
projector, or the projection lens.
Diagnostics and Calibration
1. Test Pattern
2. Grey Level
3. Freeze Image
4. Color Enable
5. Odd Pixel Adjustment
6. Reserved
7. Peak Detector
8. Level Detector
9. Level Value
Aspect Ratio Overlay
0.
Lens Center
ILS Calibration
Figure 2-14 Diagnostic and Calibration Menu
Always re-install a lens in its previous "UP" orientation, otherwise boresight may require re-
2)
Grid
512
White
512
Reference Calibration
Figure 2-13 Tether Lens
to Projector
Roadie HD+35K Setup Guide
020-100394-02 Rev. 1 (01-2010)