Christie Roadie HD+35K Setup Manual page 12

Section 2: Installation and Setup
2. Install the Lamp and Lens.
Refer to Section 2.3 Installing Lens, Lamp, and Cooling
3. Connect the source to the appropriate connector(s) on the main Input panel (lens side of the projector),
shown in Figure
4. Connect to Ballast and Power.
Head to Ballast
Connect all four ballast cables
• 2 DC power cables
• 2 communication/control cables
2-2
2-2.
Connect and Input Source to Side Panel
Figure 2-2 Connect to Input Panel
1) Connect all four cables to the projection head prior to turning the breaker/power
switch ON. 2) Follow all labeling exactly.
(Figure 2-3):
for installation instructions.
Roadie HD+35K Setup Guide
020-100394-02 Rev. 1 (01-2010)