Christie Roadie HD+35K Setup Manual page 14

Section 2: Installation and Setup
There is no other indication of
NOTE:
Breaker/Power
Switch in ON position
Head-to-AC
Connect the Christie-supplied IEC 320 (220V) 15-amp line cord to AC
other cords. Input power required is 200 - 240 VAC (nominal), 50/60 Hz @ 3A for 208V.
2-4
ballast ON
"
NOTE: Internal Incoming Line Voltage
4.
3-phase
3.
Check
status
Voltmeter (400V)
Figure 2-4 Ballast Connection and Breaker/Power Switch ON
Projector Rear
Figure 2-5 Connect Head to AC
status.
"
switch setting must match AC available at the site.
Interlocks
Control
6' line cord
2.
Connect to AC supply:
• 200 VAC in N. America
• 208 VAC in Japan
• 380/400/415 VAC in Europe
(Modify plug as necessary)
To AC
200-240 VAC
1.
Connect
+ DC
to projector
– DC
(Figure 2-5). Do not substitute
Roadie HD+35K Setup Guide
020-100394-02 Rev. 1 (01-2010)