Christie Roadie HD+35K Setup Manual page 19

When hoisting/rigging a single projector using its handles, do the following:
1. Remove the projection lens. Refer to Section 4.5, Replacing a Lens in the Roadie HD+35K User Manual.
2. Clamp the 4 rigging clamps to the projector's handles staying within the assigned rigging zones. Refer to
Figure 2-10
not tighten the cross bolt of the clevis arms to ensure the rigging clamp can swivel freely.
Symmetrical placement of the clamps on each side of the handles is strongly recommended.
NOTE:
3. Secure the other end of each clamp to the primary support structure.
4. Secure the projector with an additional two safety straps. Using one safety strap per crossbeam, route the
strap through the bottom 2 eyebolts and bring them up, and around the outside of the handles. Refer to
Figure 2-11.
5. Install the projection lens and secure it with the safety ring and tether strap as described in
Installing Lens, Lamp, and
Roadie HD+35K Setup Guide
020-100394-02 Rev. 1 (01-2010)
and Figure 2-11, and allow a minimum of 12 inches between clamps for proper stability. Do
Cooling.
Figure 2-10 Securing Clamps to Projection Head
1) CRITICAL SAFETY is a minimum of 4 rigging clamps are required for a single
projector. 2) Always use redundant safety straps/cables. 3) Observe load ratings and
all local applicable codes.
Section 2: Installation and Setup
Clevis
Maintain
swivel
Section 2.3
2-9