Christie Roadie HD+35K Setup Manual page 15

At this point, the projection head is in "standby" mode only. The voltmeter displays the incoming voltage,
the adjacent main PROJ. STATUS light yellow, and the light engine compartment fans running. The rest of
the projection head should be OFF.
5. Before switching the projector ON and igniting the lamp, define which size lamp is installed to avoid
severely over driving or under driving a lamp.
a. Press M
4500 or 6000 watts, depending on its last setting (factory default=6000).
b. Enter the Lamp password. See
The password is required unless the
NOTE:
c. Press P
d. When the Status Display shows the correct lamp type, the projector and lamp can be switched ON.
Ensure the lamp type is also indicated on the lamp door label. If not, record with a sticker or dry erase
marker.
Once the Status Display shows the correct lamp type, the projector and lamp can be switched ON.
Lamp size can also be changed in the Service menu (Service password required) if the projector is
NOTE:
running, but it will not take effect until the next power-u p. Whenever possible, define the lamp size
before igniting the lamp .
6. Using either the built-in keypad or the standard IR remote, do one of the following to switch the projector
ON, and ignite the lamp:
• press and hold P
Roadie HD+35K Setup Guide
020-100394-02 Rev. 1 (01-2010)
Do not attempt operation if the AC level is not within the specified voltage, and
power range for the projection head.
Explosion hazard. Keep the projection head OFF until you have defined which lamp
type is installed.
. The Status Display at the rear of the projector displays a "Lamp Size" of 2000, 3000,
ENU
and use the U
A
OWER P RROW
HOW TO SET THE LAMP SIZE:

Or standard Christie service password.
Figure 2-6 Setting Lamp Size
for at least two seconds
OWER
Figure 2-6.
Enable Password
" "
to locate and select which lamp is currently installed.
1.
Menu
2. Enter Lamp Password:
1
3.
Lamp Size
6000
Select installed lamp size:
2000
3000
4500
6000
Section 2: Installation and Setup
service option has been turned OFF.
Press "Menu" before power up.
Screen below displays lamp size.

on built-in
Input 3 Input 1 Input 4 Input 1
keypad
or
on the
4
7 0
standard
IR remote
on built-in
keypad
or
on the
standard
IR remote
2-5