Infors HT Multitron Standard Operating Manual page 41

17 March 2021
Prior to the shaking process, gently pull on every vessel to en-

sure they are all stuck on firmly.
If the humidity is too high or the temperatures are too low or if

there are extreme jumps in temperature (e.g. when using the
timer function), keep an eye on condensate. Condensate can
result in vessels detaching from the adhesive matting.
To remove vessels, gently and evenly pull or push on the neck

and wait a few seconds.
Never use force!
In case of large vessels, it can take 20 to 30 seconds until they

detach from the adhesive matting.
Vessels that are stuck can be removed from the adhesive mat-

ting by using a syringe to inject water under the flask.
Due to their shape (wide base, short neck), Fernbach flasks in

particular can be difficult to remove. If necessary, cover part of
the adhesive matting with the protective foil provided.
The adhesive power can deteriorate over time due to dust and

dirt. To clean and restore full adhesive power, thoroughly wipe
down the surfaces with a brush or a dish sponge and clear wa-
ter with mild detergent (dishwashing liquid). Then let dry over-
night.
Quaternary ammonium compounds are suitable for disin-

fection.
Consider application times and thoroughly rinse with water. If

the adhesive matting is disinfected at regular intervals, it might
need to be replaced sooner.
To replace the adhesive matting proceed as follows:
1. Thoroughly spray the tray with water
2. On one side, peel the adhesive matting off the tray and pull it
up diagonally.
3. Use acetone to degrease the tray and apply new wet adhesive
matting (according to separate installation instructions). Only
peel off protective foil prior to use.
Multitron Standard - Operating Manual
Accessories
Page 39 of 114