Advertisement
Adaptive Trim Tab System
3.2
Tab installation — standard and edge mount tabs
Position the tab (fig
mately 1/4" (6mm) up from the bottom of the hull and parallel to the hull. See
also figure
.
1
If mounting in a pocket, center the tab in the pocket.
Mark the hinge hole pattern on the transom as shown in figure
Drill holes in the transom at the marked locations with a 3/16" (4.8 mm) drill bit
to a depth of 1-1/4" (32 mm) as shown in figure
3
2
4
EN
item 1) so that the hinge plate (fig
3
1
item 2) is approxi-
3
.
3
.
4
5
Advertisement
