Advertisement
Adaptive Trim Tab System
Important things to consider when building a CAN network:
• Every network must have two – and only two – terminating resistors, one at
each end of the backbone. One male and one female terminator are included
in your installation kit.
• The backbone must be connected linearly. Do not branch the backbone at a
node connector.
• Devices always connect to the drop connector. Do not connect to the
backbone connector.
• Do not cap unconnected nodes with a terminating resistor. Either remove the
node or install a sealing cap.
• Consider the length of the drop harnesses when mounting the tees. It is
preferable to build the network backbone so that the tee is within reach rather
than extending the harness.
• Do not use tools to tighten the connectors. Hand-tighten only.
All kits include harnesses for each component in your system. If you need longer
harnesses, you can order extensions from table 5-1.
Description
Micro C Extension, Male/Female
Table 5-1.
5.2.2
CAN tee installation
Install tees in a dry location.
Secure the tees and harnesses as shown in figure
Mark the connections with a felt marker. This will make loose connections visible.
EN
Micro-C DevicNet harness
Length, ft (m)
1 (0.3)
3 (0.9)
6 (1.8)
9 (2.7)
12 (3.6)
16 (4.9)
20 (6.1)
30 (9.1)
Part No.
CM10001
CM10003
CM10006
CM10009
CM10012
CM10016
CM10020
CM10030
.
14
17
Advertisement
