Advertisement
To enter setup mode:
Key on the ignition.
Simultaneously press and hold the Bow Down and Bow Up buttons for
five seconds.
✓ The status LED will alternate blue and magenta.
✓ The port LEDs are all off, indicating that you are in step 0.
6.2.1
Step 0 — Actuator and controller instancing
The system will detect the number of devices on the network, but they need to
be instanced. That is, you must tell the system which actuator(s) are port, which
are starboard, and which dial controller is main. The controller you use for setup
is automatically instanced as the main controller, so you only need to instance the
actuators manually.
When you enter Step 0 the controller LEDs will illuminate as shown. If you haven't
yet instanced the actuators the LEDs representing them will flash. When properly
instanced they illuminate solid. If only the top LED is flashing, there is an error in one
of the instances and you should repeat the instancing procedure.
31
To instance the actuators:
Unplug the starboard actuator at the three-pin communication harness (figure
In an HD system with two actuators you must unplug both actuators.
Plug the actuator(s) back in.
✓ The stbd LEDs will stop flashing and become solid.
36
BY
Adaptive Trim Tab System
NUMBER OF TRIM TAB
ACTUATORS FOUND
ALTERNATES BLUE
AND MAGENTA
NUMBER OF DIAL
CONTROLLERS FOUND
).
32
EN
Advertisement
