Adaptive Trim Tab System
Liberally apply marine grade sealant to the bracket, grommet, mounting holes
and to the harness entry.
Double check that there is a small amount of slack in the harness between the
bracket and the entry into the actuator (fig
item 2). Mate the bracket to the
12
hull, and install the 2 screws (fig
item 1). Do not over-tighten the screws.
12
This is done to ensure the center screw does not damage the actuator harness
during installation.
12
2
1
3
When the bracket is fixed to the hull, remove the pivot bolt (fig
item 3) and
12
lower the actuator to create clearance for the final screw, taking care not to pull
the actuator harness out of the hull. Install the final screw, again taking care not
to over-tighten. Reinstall pivot bolt, including the washer provided beneath the
nut. Tighten nut to 30–40 in-lbs. Take care not to over-tighten.
11
EN