Advertisement
Adaptive Trim Tab System
Installation:
Mount a tee for each actuator and controller in your system.
Review the requirements for the network power (page 21) and determine the
best location for the network power tee. It may not be as shown in the diagrams.
Connect the tees with harnesses to build the CAN network backbone. Route the
harness(es) so they are dry, away from sources of heat, and properly secured.
Install one network terminator at each end of the backbone.
Connect the devices to the network (section 5.4).
16
CONTROLLER
DEVICENET
CM10003
3' HARNESS
(LONGER LENGTHS
AVAILABLE)
EN
CM20043
3' COMMUNICATION
HARNESS (x2)
HARNESS
6' ACTUATOR HARNESS (x2)
NETWORK
CM10060
TERMINATOR
NETWORK
TEES
NETWORK POWER
OR
3 PIN DEUTSCH
CONNECTOR (x2)
(USER-INSTALLED)
TRIM TAB
ACTUATOR
(x2)
19
Advertisement
