Advertisement
Adaptive Trim Tab System
Lift the tab into the running position as shown in figure
not drag when retracted, they must be tilted up from the hull level. The longer the
tab, the greater the height above the hull level at the trailing edge of the tab. You
will need a long straight edge, such as a carpenter's level, and a helper for this step.
Once the tab angle is correct, position the transom bracket flush against the
hull. Ensure that it lays naturally against the hull, with no force to the side.
NOTICE! Actuator wear
Misalignment will cause accelerated wear of the actuator.
Trace the outline of the mounting bracket (fig
Remove the bracket from the actuator, line it up with the traced outline, and
mark the mounting holes and the harness hole.
Drill the mounting holes with a 3/16" (4.8 mm) drill bit to a depth of 1-1/4" (32 mm).
Drill a 3/8" (9.5 mm) hole through the transom for the wiring harness.
NOTICE! Potential damage
Ensure there is nothing behind the hull that could be damaged by
drilling the hole through the hull for the cable.
Now that the holes are drilled, you're ready to mount the actuator to the hull.
9
2
1
EN
3
4
8
. To ensure the tabs do
8
item 2) on the hull.
9
5
6
7
9
Advertisement
