Advertisement
Ensure the actuator shaft (fig
until travel stops. The shaft can safely be forced to continue rotating clockwise
to align the mounting holes at each end of the actuator. The actuator should
come in this position out of the box, so adjustment may not be necessary.
Insert the pivot bolt (fig
shaft. Install the washer and nut (fig
in-lbs. Check that the actuator shaft pivots freely. A small amount of resistance
to movement is acceptable, but it must not bind or require more than a few
pounds of force to move. If necessary, loosen the nut slightly.
Install the foot bracket (fig
screws (fig
item 1) and nuts (fig
7
bottom of the tab. Torque the foot bracket fasteners (fig
to 60–70 in-lbs. in place of instruction to tighten until snug.
NOTE
If a 10" or 12" actuator is being installed, install screws into the threaded
inserts in the foot brackets provided.
8
1/4"
(6.4 mm)
0
8
item 9) is fully retracted by rotating it clockwise
7
item 8) through the foot bracket and the actuator
7
7
item 3) to the tab (fig
7
7
3/8"
(9.5 mm)
4"
(102 mm)
(229 mm)
TAB LENGTH
Adaptive Trim Tab System
item 10 and item 4) and tighten to 30–40
item 2) using the supplied
7
item 5). Insert the screws from the
TRAILING EDGE HEIGHT
(RECOMMENDED HEIGHT INCREASES
AS BLADE LENGTH GETS LONGER)
5/8"
1/2"
(15.9 mm)
(12.7 mm)
9"
12"
14"
(305 mm)
(356 mm)
item 1 and item 5)
7
1"
7/8"
3/4"
(25.4 mm)
(22.2 mm)
(19.0 mm)
16"
18"
(406 mm)
(457 mm)
EN
Advertisement
