Advertisement
Adaptive Trim Tab System
32
✓ The actuator(s) you unplugged are instanced as starboard. The actuator(s) that
remained plugged in are instanced as port.
✓ On HD installations with two actuators per tab, the lower serial number will be
instanced as main, the other will be second.
Press the Favorite button to save and continue to Step 1.
✓ One port LED illuminates to indicate you are in Step 1.
6.2.2
Step 1 – 8
Most of these parameters will be set during the testing and commissioning phase
of the installation (section 7).
Table 6-3 lists the parameter for each step of the setup and the parameter value
corresponding to the number of stbd LEDs that are illuminated. It also lists the
parameter units and tells you where you can find a detailed parameter description.
For each step:
Rotate the dial to increase or decrease the parameter to the desired value.
Press Favorite to save the parameter and move to the next step.
Press Home to exit when setup is finished, or if you need to exit before completion. The
current parameter will not be saved, but previously saved parameters are not affected.
NOTE
When configuring SOG and RPM parameters, if the actual SOG or RPM
is between the available values select the higher value. For example, if
actual Planing Boat RPM is 3500, select 3700.
EN
37
Advertisement
