Adaptive Trim Tab System
Installation:
Mount a tee for each actuator and controller in your system.
Run harnesses as required to connect the tees to the CAN2 network
backbone. Route the harness(es) so they are dry, away from sources of heat,
and properly secured.
Check that there is one network terminator at each end of the backbone.
Connect the devices to the network (section 5.4).
20
CONTROLLER
DEVICENET
TO
OPTIMUS
CAN2
NETWORK
CM10003
3' HARNESS
(LONGER LENGTHS
AVAILABLE)
EN
CM10060
NETWORK
TEES (x3)
CM20043 3' COMM.
HARNESS (x2)
HARNESS
6' ACTUATOR HARNESS (x2)
NETWORK
TERMINATOR
OR
3 PIN DEUTSCH
CONNECTOR (x2)
(USER-INSTALLED)
TRIM TAB
ACTUATOR
(x2)
23