Advertisement
Boat has a NMEA2000-compliant network
Add a tee to the existing public network.
Remove the sealing cap from the port marked 'N2K' on the main station
dial controller.
Use a harness (table 5-1) to connect the dial controller N2K port to the tee.
Secure the harness at both ends for strain relief.
Coil up any slack in the harness and secure it.
Boat does not have a NMEA2000-compliant network
NOTE
It is not mandatory that you install a NMEA2000 network, but it is
required to get the full functionality of the Adaptive Trim Tab system.
You will need kit CM20003. It includes everything you need to build the small
network shown in figure
Assemble the power drop tee to the multi-port tee and install the assembly
close to the main station dial controller. Install the terminating resistors.
Wire the power drop tee to a 3A fused 12V power source (see figure
sample power connection).
Connect an engine gateway to one of the open nodes.
Remove the sealing cap from the port marked 'N2K' on the main station
dial controller.
Use a harness (table 5-1) to connect the dial controller N2K port to the other
open node.
Secure all the harnesses at both ends for strain relief. Ensure they are all routed
neatly and securely, with any slack coiled up.
32
:
28
Adaptive Trim Tab System
for a
18
EN
Advertisement
