Advertisement
Adaptive Trim Tab System
6
Setup
The Adaptive Trim Tab System needs to be configured before use. Setup is done
with a CANtrak display (section 6.1) or the dial controller (section 6.2).
6.1
Setup with display
NOTE
If the boat is not equipped with a CANtrak display, you will need to add
a temporary tee to the CAN network and connect a display tool to it.
You will need software version SW0292RevAA or higher on the display.
6.1.1
Basic setup
The system will detect the number of devices on the network, but they need to be
instanced. That is, you must tell the system which actuator(s) are port, which are
starboard, and which dial controller is main.
From the dealer menu:
Go to Initial Setup > System > Select Device Locations.
✓ Actuators and dial controllers will be displayed with their serial numbers and
assigned an instance by default.
Record the device serial numbers. The serial numbers are 12-digit alphanumeric
strings, found on the back of the controller (starting "TTC") and on the end of
the actuator harness (starting "TTA").
Match the serial number for each actuator and controller and use the + and –
buttons to adjust the instance location as required.
EN
33
Advertisement
