Advertisement
The system status
LED is flashing red.
One or both tab
position indicators
are flashing.
Holeshot mode
won't activate.
Holeshot
performance
is poor.
When in holeshot
mode, status LED
changes from
magenta to
lime green.
46
Tab(s) with blinking
position indicators
are not making
position.
Missing speed
source.
Holeshot Mode is
disabled.
Sea conditions
are different than
the mode was
tuned for.
Holeshot settings
have not been
optimized.
System has lost a
valid SOG source.
Adaptive Trim Tab System
Check the harness connections
for the affected actuator(s) and
make sure they aren't loose or
disconnected.
Check that nothing is physically
preventing the tabs from moving.
If only one position LED is flashing:
switch off power, swap the
connectors between the two
actuators and try adjusting the trim
again. If the actuator still does not
move it will need to be replaced.
If the problem changes sides,
then there is a problem in the
communication or power harness.
Ensure you have an engine RPM or
SOG source correctly installed
and configured.
Ensure at least one engine is running.
Ensure engines are not in reverse
gear.
Ensure joystick (if equipped) is not
activated.
Enable Holeshot mode. See
section 6.3.
Adjust trim manually.
Tune the system as shown in
section 7.1.
Wait for system to re-establish a
valid source.
EN
Advertisement
