Advertisement
Adaptive Trim Tab System
Use red wire of the size shown in table 5-3 to connect the breaker to the insulated
stud connector. Take care to route and secure the wire properly.
If there is no negative bus aft, install one and connect to the battery -ve with
black or yellow wire of the size shown in table 5-3.
Connect the actuator harness as described in the previous section.
Total length of wire from power source to power
harness connection and back to source
Table 5-3. *Based on 10% voltage drop per ABYC E-11.
5.6
Step 6 — Connect public network
The Adaptive Trim Tab system reads engine RPM and gear position from this network
and broadcasts the trim tab positions for display on MFDs. In a multi-station boat,
only the main controller should be connected to a public network.
29
N2K
EN
< 18' (5.5m)
< 48' (14.6m)
< 78' (23.8m)
< 138' (42m)
MAIN STATION
CONTROLLER
CM100XX
Recommended wire
size AWG (mm
PUBLIC NETWORK
12 VOLT POWER
)*
2
12 (4.0)
10 (6.0)
8 (10)
6 (16)
ENGINE NMEA2000
INTERFACE
31
Advertisement
