Adaptive Trim Tab System
Slide the mounting bracket (fig
item 2) over the actuator harness (fig
item 6)
9
9
until you can mate it with the actuator (fig
item 7).
9
Fit pivot bolt (fig
item 5) through the joint without installing thewasher and nut
9
(fig
item 8 and item 1).
9
Grease the sealing grommet (fig
item 4) and slide it over the harness. Apply
9
marine sealant to the sealing surface, then adjust it until it contacts the bracket.
While the sealant is still pliable, adjust the slack in the harness by pulling it snug
with the bracket rotated down as shown in figure
.
10
10
PULL
BRACKET ROTATED
CABLE
DOWN
SNUG
Slide the harness compression plate (fig
item 3) over the harness until it fits
9
in the recess in the rear of the bracket as shown in figure
. Some sealant on
11
the mating surfaces will help keep the compression plate in place during the
following steps.
11
✓
✗
Insert the harness into the hole in the hull and feed it through until the actuator
bracket is almost at the hull.
10
EN