Adaptive Trim Tab System
5.3
Step 3 — Install connectors on actuator harnesses
The actuators come with a 6' (1.8m) harness containing the five conductors listed
in table 5-2. The conductors are fitted with crimped terminals, but the connectors
must be installed after the harness has been routed into the boat and sealed. These
connectors will mate with the power and communication harnesses that come with
the actuator kit.
To install the connectors:
Refer to table 5-2 to determine the wire pinouts.
Wire Color
White
Blue
Purple
Red
Black
Table 5-2.
Grip the wire just behind the crimped contact barrel and hold the connector with
the grommet facing you.
Push the contact straight into the grommet until you feel a positive stop.
You will hear a click and the contact will lock into place. A tug on the wire will
confirm that it is properly secured
22
EN
Function
Connector
CAN High
CAN Low
Wake-up
12V Battery +ve
12V Battery -ve
A
B
C
Pin ID (molded
into connector)
J1 - 3 pin
J1 - 3 pin
J1 - 3 pin
J2 - 2 pin
J2 - 2 pin
NOTE POSITION
WHITE WIRE
A
B
C
1
2
25