Advertisement
Adaptive Trim Tab System
5.4
Step 4 — Connect devices to the private network
5.4.1
Dial controller
The dial controller has two connectors on the back, labeled 'CAN2' and 'N2K.' The
N2K port is shipped with a sealing cap; leave it in place unless you are connecting
to a public network (section 5.6).
For each dial controller:
Connect the female end of the supplied harness (CM10003) to the port
labeled 'CAN2.'
Connect the male end of the harness to the network tee. (Use an extension
harness from table 5-1 if the harness is not long enough.)
Secure the harness at both ends for strain relief.
Coil up any slack in the harness and secure it.
25
5.4.2
Adaptive actuator
The communication harness (CM20043) has a 3-pin triangular connector at one
end and a round connector at the other end. For each actuator:
Plug the communication harness into the mating connector on the actuator
harness until the lock engages. (section 5.3).
Connect the round connector to a network tee.
Secure the communication harness at both ends to relieve strain on the connectors.
Coil and secure any slack in the actuator harness.
EN
CAN2 PORT
27
Advertisement
