Advertisement
15
ALL NUTS DOUBLE
CHECKED FOR TIGHTNESS
AND MARKED
EACH CABLE
APPROPRIATELY
SECURED AND
STRAIN RELIEVED
CLOSE TO TEES
NO PULLING
ON TEES
5.2.3
Network installation — Adaptive Trim Tab
NOTE
If the boat is equipped with Optimus EPS, skip to section 5.2.4.
The CAN network is shown in figure
Installation notes:
• Your kit will include device tees, terminating resistors, and a power drop tee,
but the backbone harness(es) must be ordered separately (table 5-1).
• The combined length of the actuator and communication harness is 9' (2.7m).
The actuator tees must be within reach of the properly routed, protected, and
secured harness. You may be able to mount the actuator drop tees together, or
it may be better to mount them closer to the sides of the boat with a backbone
harness joining them.
• The location of the actuator power source (section 5.5) may affect the reach of
the communication harness.
18
(single controller) and figure
15
Adaptive Trim Tab System
SCREWS IN ALL
MOUNT HOLES
NOTE: TEES MAY NOT LOOK
EXACTLY AS SHOWN
(dual controller).
16
EN
Advertisement
