Configure Receipt Header And Footer - Ingenico iCT2XX Operating Manual

SKYZER TECHNOLOGIES
5.8

Configure Receipt Header and Footer

This function allows the merchant to customize the receipt merchant name
and address lines.
NOTE: The footer lines will only be printed off on the customer copy of the
receipt.
Step Terminal Display Comment
1.0
2.0
FUNCTION?
3.0
CONFIG RECEIPT
HEADER & FOOTER?
ENTER OR CLEAR
4.0
ERASE EXISTING
HEADER & FOOTER?
ENTER OR CLEAR
5.0
MERCHANT NAME
XXXXXXXXXXXXXXXX
6.0
ADDRESS LINE 1
XXXXXXXXXXXXXXXX
7.0
ADDRESS LINE 2
XXXXXXXXXXXXXXXX
8.0
FOOTER LINE 1
XXXXXXXXXXXXXXXXXX
9.0
FOOTER LINE 2
XXXXXXXXXXXXXXXXXX
INGENICO ICT2XX PTS2018 PAYMARK OPERATING MANUAL
Press FUNC
Enter 3825, press ENTER
Press ENTER to configure the parameters or CLEAR to cancel and return to idle
screen
Only applicable if header and footer was previously configured
Press ENTER to erase the existing header and footer or CLEAR to keep the
previous configuration and make minor alteration to the header and footer.
This parameter specifies the Merchant Name. It can be configured by entering the
desired Merchant Name using the numeric keypads then the FUNC key to access the
alpha characters then press ENTER
Note: Up to 20 characters can be entered per line.
This parameter specifies the address in which you would like to appear on printed
receipt. NOTE: Two address lines can appear on printed receipted
Example: Address Line 1 -
This parameter specifies the address in which you would like to appear on printed
receipt. It can be configured by entering desired use the numeric keypads then the
FUNC key to access the alpha characters then press ENTER
Example: Address Line 2 -
This parameter allows up to ten lines of text to be printed at the bottom of the
cardholder's copy of the receipt.
It can be configured by entering desired footer use the numeric keypads then the
FUNC key to access the alpha characters then press ENTER
Prompts will be shown for successive footer lines.
1066 COOKS RD
PENROSE
PAGE 58 OF 147
Version 1.00