Ingenico iCT2XX Operating Manual page 44

SKYZER TECHNOLOGIES
5.0
TERMINAL ID?
XXXXXXXX
6.0
MERCHANT ID?
XXXXXXXXXXX
7.0
NII?
001
8.0
COMMS MODE?
1-DIAL-UP
2-TCP-IP / DIAL
3-TCP-IP
4-GPRS
5- GPRS / Dial
6-TCP-IP / GPRS
7-TCP-IP/GPRS/DIAL
8-DIAL / GPRS
9.0
COPY CONFIG TO
ALL MERCHANT Y/N
10.0
PLEASE WAIT
11.0
CONFIG ANOTHER
MERCHANT Y/N
INGENICO ICT2XX PTS2018 PAYMARK OPERATING MANUAL
This parameter specifies the Terminal ID that Paymark assigns to the terminal.
Press ENTER.
This parameter specifies the Merchant ID assigned by Paymark.
Press ENTER.
This parameter specifies the Network International Identifier (by default 001) that
the terminal uses to route messages to Paymark.
Press ENTER.
To configure COMMS mode:
Press 1 for Dial-up configuration followed by ENTER and proceed with the
configuration as on page 26.
Press 2 for TCP-IP/Dial as backup configuration followed by ENTER and
proceed with the configuration as on page 27.
Press 3 for TCP-IP configuration followed by ENTER and proceed with the
configuration as on page 29.
Press 4 for GPRS configuration followed by ENTER and proceed with the
configuration as on page 30.
Press 5 for GPRS with Dialup as backup configuration followed by ENTER
and proceed with the configuration as on page 31.
Press 6 for TCP-IP/GPRS as backup configuration followed by ENTER and
proceed with the configuration as on page 33.
Press 7 for TCP-IP/GPRS/Dial-up as backup configuration followed by
ENTER and proceed with the configuration as on page 35.
Press 8 for DIAL/GPRS as backup configuration followed by ENTER and
proceed with configuration as on page 37.
Proceed with the configuration as normal, until CONFIG TO ALL MERCHANT
Y/N prompt and proceed as below.
This feature allows the merchant to copy the configuration from COMMS mode and
below to the entire active merchants if communicating through same medium.
Press ENTER to copy the current configuration to the entire active merchants or
CLEAR to cancel and proceed with configuring each merchant for its required
COMMS mode.
PLEASE WAIT will be displayed while copying the current merchant configuration
to the other active merchants.
Press ENTER to proceed with the configuration of the next merchant or CLEAR to
cancel and exit out from the merchant configuration.
PAGE 44 OF 147
Version 1.00