General Maintenance
N O T E
U2300A Series DAQ User's Guide
Repair or service which are not covered in this manual should only be
performed by qualified personnel.
To remove the dirt or moisture of the DAQ device, follow the
instructions below.
1 Power off your DAQ device and remove the AC/DC adapter cord
and I/O cable from your device.
2 Remove your DAQ device from its plastic casing by pulling at
the bumper (front end of the casing) in an outward direction.
Then, lift the plastic body casing and remove it from your DAQ
device.
3 Holding your DAQ device, shake out any dirt that may have
accumulated on the panel of your DAQ device.
4 Wipe your DAQ device with a dry cloth.
Getting Started
1
23