Connect Your Device To The Pc - Agilent Technologies U2300A Series User Manual

E. Connect Your Device to the PC
U2300A Series DAQ User's Guide
1 After all installations have been successfully completed, connect
the power cord to the AC/DC power adapter. The AC/DC power
adapter requirements are 110 V/240 VAC, 50/60 Hz, with output
voltage of +12 VDC.
2 Insert the DC output plug from the AC/DC power adapter to the
power jack on the rear panel of the USB device.
3 Connect any of the U2300A series instrument to any USB ports
on your PC with the USB cable.
4 If this is the first time you connect the instrument to your PC,
the Found New Hardware Wizard window will appear as shown
below. Select Yes, this time only and click Next to proceed.
5 Select Install the software automatically (Recommended) and
click Next.
6 A warning message will appear in Hardware Installation
window, as shown below. Click Continue Anyway to proceed
with the installation of the driver.
Getting Started 1
17