Figure 3-6 Totalizer Mode - Agilent Technologies U2300A Series User Manual

3 Features and Functions

Figure 3-6 Totalizer mode

N O T E
62
Totalizer mode
In totalizer mode, the counter will start counting the number
of pulses generated on COUNT_CLK. This is done after the
GATE is enabled. The totalize count is measured with the
following command:
MEASure:COUNter:TOTalize? (@301)
The example below illustrates the count up mode when the
counter is configured as totalize with initial count set to 0.
COUNT_GATE will enable the counting after the totalize
function has been enabled and the COUNT_OUT pin will
output a series of pulses as shown below.
The output pulse width is at 20.8 ns.
U2300A Series USB DAQ User's Guide