Agilent Technologies U2300A Series User Manual page 71

N O T E
U2300A Series USB DAQ User's Guide
Example 2, To output two DC voltages via CH 201 and CH 202
-> *RST;*CLS
-> SOUR:VOLT 3.5, (@201) // Set 3.5 VDC output to CH 201
-> SOUR:VOLT 8.1, (@202) // Set 8.1 VDC output to CH 202
Continuous output mode
The continuous output mode consists of function generator
and arbitrary. You can use the following SCPI commands in
arbitrary mode:
DATA[:USER]
APPLy:USER
For further information, refer to the Agilent U2300A Series USB Multifunc-
tion Data Acquisition Programming Guide .
Example 3, To output a sine wave via CH 201
-> *RST;*CLS
-> ROUT:ENAB ON, (@201)
-> APPL:SIN 5, 0, (@201)
-> SYST:ERR?
<- +0, "No Error"
-> OUTP ON
-> OUTP:WAV:FREQ? (@201)
Features and Functions
// To reset DAQ to default power-on
state, this command can be ignored if
this operation is not required
// To reset DAQ to default power-on
state, this command can be ignored
if this operation is not required
// Enable CH 201
// Sine wave with 5 Vp (10 Vpp) and
0 VDC offset
// To check for any error, this
command can be ignored if this
operations is not required
// Turn on output
3
53