Cooling fan reverse mode
· Manual
: Rotate the fan with reverse direction while pressing the button "Execute".
· Automatic
: Rotate the fan with reverse direction by preset cycle.
- Interval : 30 min ~ 5 hrs
- Time : 30 sec ~ 5 min
Default : Interval (60 min), time (120 sec)
Wiper level setting (Intermittent mode)
•
Setting wiper speed in J position of multi fumction switch (slow, normal, fast and very fast)
Refer to the page 3-57.
Calibration
•
You should turn OFF " Soft end stop " before start calibration.
•
Press NEXT button after following the instruction at each step.
•
If correction is right, NEXT button will be activated, then go to next stage.
•
After following each step correctly, the message "Calibration completed" will be shown.
Press OK button, then process be ended.
Using switch
-
Using
instead of NEXT, complete button.
Automatic
3-28
Manual