Loading And Unloading By Crane - Hyundai HL930A Operation & Maintenance Manual

5. LOADING AND UNLOADING BY CRANE

1) Check the weight, length, width and height of
the machine referring to Section 2, Specifica-
tions when you are going to hoist the machine.
2) Use long wire rope and stay to keep the dis-
tance with the machine as it should avoid to
touch with the machine.
3) Put a rubber plate between the wire rope and
the machine to prevent damage.
4) Place the crane on the proper place.
5) Install the wire rope and stay like shown on the
illustration.
Make sure that the wire rope is of the proper
size.
Place the safety lock bar and pilot cut off
switch to the OFF position to prevent the
machine moving when hoisting the machine.
The wrong hoisting method or installation of
the wire rope can cause damage to the ma-
chine.
Do not load abruptly.
Keep the area clear of personnel.
Attach two wire ropes to the rear of the ma-
chine. Attach two wire ropes to the front of
the machine. Connect the four wire ropes.
Wire rope
Wire rope
5-6
Stay
Stay
Stay
REAR VIEW