Hyundai HL930A Operation & Maintenance Manual page 40

Wheel loader
Hide thumbs Also See for HL930A:
Table of Contents

Advertisement

Please note that the machine is wider and trav-
els at a lower driving speed than other vehicles
on the roads.
Pay attention to any vehicles behind your vehi-
cle, and allow them to overtake your vehicle
safely.
Check the following conditions before driving
the machine on the public road :
-
Remove any dirt and sand from the ma-
chine.
-
Empty the bucket and move it to the driving position (40~ 50 cm above the ground) and fix it.
-
Close the windshield. Turn the working light off.
-
Wear the seat belt.
-
Use the lighting devices, such as the headlights, emergency warning light and rotating bea-
con, pursuant to the local road traffic legislation.
-
Pay attention to people in the vicinity of the machine.
-
Do not operate the machine on roads or bridges where the machine exceeds the weight limit.
-
Familiarize yourself fully with the width, length and height of the machine.
-
Check the tire pressure.
-
When traveling for a long distance, stop the machine after every 40 km or on an hourly basis,
and take a break.
-
Check the level of fuel and coolant.
-
Never shift the gear to the neutral position when driving down a slope.
-
Changing direction when operating the machine on a slope is dangerous.
-
Do not drive on a slope of 30° or more.
-
Drive slowly when traveling the machine on rough terrain or moving over obstacles.
-
Install chains on the tires when operating the machine on slippery roads covered with snow or
rainwater, and do not attempt to start, stop or turn the machine suddenly.
-
Be sure to avoid any obstacles when traveling the machine on paths.
9) Operations to be avoided or prohibited
Pay attention when operating the machine in an
enclosed space as this may result in the risk of
a buildup of hazardous gases.
If the machine is operated in the vicinity of a
high-voltage line, there is a risk of death or seri-
ous injury.
Make sure you are fully aware of the height and
working radius of the machine, and maintain the
minimum safety distance.
Voltage
6.6 kV
33.0 kV
66.0 kV
154.0 kV
275.0 kV
Minimum safety distance
3 m (10 ft)
4 m (13 ft)
5 m (16 ft)
8 m (26 ft)
10 m (33 ft)
1-16
Driving position

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hl930a xt

Table of Contents