Table of Contents
Advertisement
WXR720/L, WXR740/L
Trailer Wood Splitter
11. Do not try to split logs across the grain. Some
types of wood can burst or splinter causing pieces
to be thrown causing injury.
12. For uneven cut logs, always place the square cut
end against the splitting wedge.
13. Never place any part of your body where it
would be in danger if machine movement should
occur during assembly, installation, operation,
maintenance, repairing or moving.
14. Before servicing or repairing the machine, place it
in a Safe Condition. See page 10.
6.2
Before Starting the Engine
1. Check the engine oil level. See page 24.
2. Check the hydraulic oil level. See page 24.
3. Check the fuel level.
4. Check the engine air cleaner. See page 26.
5. Review the Safety Rules on page 9
6. Clear the area of bystanders, especially small
children.
7. Make sure each operator is trained and familiar
with the set up and operation of the wood splitter.
8. Follow the Pre-Operation Checklist.
9. Review the Controls (see page 20).
10. Survey the work site and place the wood splitter in
a clear, level work area.
11. Set up the machine correctly. See Machine Set-up
on page 26.
6.3
Pre-operation Checklist
Efficient and safe operation of the Wallenstein
wood splitter requires that each operator reads and
understands the operating procedures and all related
safety precautions outlined in this section.
A Pre-operation Checklist is provided for the operator.
The checklist is important for both personal safety and
keeping the wood splitter in good mechanical condition.
Before operating the machine and each time thereafter,
the following areas should be checked off:
Pre-operation Checklist
Check engine oil level. Top level up as
required.
Check hydraulic fl uid level. Top level up as
required.
Check and lubricate the machine following
the schedule outlined in the Maintenance
section.
Check the wedge and block. Be sure they
are not damaged or broken and is not badly
worn. Repair or replace as required.
Check and remove any entangled material.
Check for hydraulic leaks. Tighten
connections or replace components to stop
leaks.
Check and ensure that all covers, guards
and shields are in place, secured, and can
function as designed.
Check and inspect tires, wheels, and hubs.
Check and tighten all fasteners. Make sure
the equipment is in good condition.
Check that appropriate equipment for
personal protection is being used and in good
condition.
Check that jewelry, loose-fi tting clothing are
not worn. Make sure long hair is tied back.
23
Operating Instructions
Advertisement
Table of Contents
