Installing The Electrical Harnesses For The Sprayer - Toro Multi Pro 41240 Operator's Manual

5. Insert the 2 plastic bushings into the mounting
bracket (Figure 18).
Installing the Control Console to
the Machine
1. Remove the hairpin securing the pivot pin of the
control console to the storage bracket on the
sprayer tank.
2. Install the control console onto the control
mounting bracket and secure the control console
with the spring-clip pin
Note:
Ensure that the spring clip is rotated over
the pivot pin to positively secure the spring-clip
pin.
Figure 19
1. Spring-clip pin
2. Pivot pin (control console)
3. Install the hand knob and tighten it to prevent the
console from rotating during operation
19).
(Figure 19).
g033521
3. Control mounting bracket
4. Hand knob
(Figure
10
Installing the Electrical
Harnesses for the Sprayer
Parts needed for this procedure:
3 J-clips
1 Bolt (1/4 x 3/4 inch)
1
Flange nut (1/4 inch)
Routing the Rear Electrical
Harness for the Sprayer to the
Control Console
1. Install 2 J-clips in the center console at the
points located in
the existing screws.
HD-Series models with a manual transmission
1. J-clip
2. Existing screws
19
Figure 20 or Figure 21
Figure 20
3. Control-box harness
4. Center console
using
g002507