Toro Multi Pro 41240 Operator's Manual page 48

InfoCenter Advisories
Operator advisories automatically display on the
InfoCenter screen when a machine function requires
additional action. For example, if you attempt to
start the engine while pressing the traction pedal, an
advisory displays indicating that the traction pedal
must be in the N
EUTRAL
For each advisory that occurs, the fault indicator
flashes, and an advisory code (number), an advisory
description, and an advisory qualifier appears on the
screen as shown in Figure
Advisory descriptions and qualifiers appear as
InfoCenter icons. Refer to
for a description of each icon.
Note:
An advisory qualifier explains the conditions
that triggered the advisory and provides instructions
on eliminating the advisory.
1. Fault indicator
2. Advisory qualifier
Note:
Advisories do not log into the fault log.
Note:
You can clear an advisory from the display
screen by pressing any of the InfoCenter keys.
Refer to the table that follows for the InfoCenter
advisories:
Advisories
Advisory Code Description
200 Start prevented—pump switch active
201 Start prevented—not in N
202 Start prevented—out of seat
203 Start prevented—throttle pedal is not home
204
Start prevented—starter engage timeout
205 Parking brake is engaged
206 Pump start prevented—boom active
position.
75.
InfoCenter Icons (page 42)
Figure 75
3. Advisory description
4. Advisory code
EUTRAL
Advisories (cont'd.)
Advisory Code
207
208
209
210
211
212
213
220
221
222
223
224
225
226
231
232
g202867
233
234
235
236
237
238
241
48
Description
Pump start prevented—engine speed high
Throttle/speed lock prevented—pump is not
active
Throttle lock prevented—parking brake is
not engaged
Speed lock prevented—operator not in seat
or parking brake is engaged
Throttle/speed lock prevented—clutch or
service brake is engaged
Tank low volume alert
Rinse pump O
N
Flow sensor calibration
Flow sensor calibration—fill water in tank
and enter volume filled
Flow sensor calibration—turn on the pump
Flow sensor calibration—turn on all the
booms
Flow sensor calibration—calibration
commenced
Flow sensor calibration—calibration
complete
Flow sensor calibration—exiting calibration
mode
Speed sensor calibration
Speed sensor calibration—fill the
fresh-water tank, press next
Speed sensor calibration—fill the sprayer
half full of water, press next
Speed sensor calibration—enter the
calibration distance, press next
Speed sensor calibration—mark and drive
the entered distance with sprayer sections
off
Speed sensor calibration—speed sensor
calibration in progress
Speed sensor calibration—speed sensor
calibration complete
Speed sensor calibration—turn off the
booms
Calibration out of bounds, using default