Installing The Sprayer Supply Hose - Toro Multi Pro 1750 Installation Instructions Manual

Figure 69
1. Bypass hose—2.5 x 110 cm (1 x 43-1/2 inches)
4. Align the flange of the straight barbed fitting and
gasket—25 x 35 mm (1 x 1-3/8 inches) with the flange
of the bypass valve (Figure
5. Secure the straight barbed fitting to the bypass valve
(Figure 69) with a flange clamp—40 to 64 mm (1-9/16
to 2-1/2 inches).
68).
15
Installing the Sprayer Supply
Hose
Parts needed for this procedure:
Sprayer supply hose—2.5 x 73 cm (1 x 28-7/8
1
inches)—machines without the optional eductor kit
2 Flange clamp—40 to 64 mm (1-9/16 to 2-1/2 inches)
2 Gasket—25 x 35 mm (1 x 1-3/8 inches)
Support clamp—machines without the optional
1
eductor kit
Flange-head bolt (5/16 x 3/4 inch)—machines without
1
the optional eductor kit
Flange locknut (5/16 inch)—machines without the
1
optional eductor kit
Lower supply hose—25 x 66 cm (1 x 25-3/4 inches)
1
machines with the optional eductor kit
Retainer (small)—machines with the optional eductor
1
kit
Upper supply hose—25 x 22 cm (1 x 8-5/8 inches)
1
machines with the optional eductor kit
Installing the Sprayer Supply
Hose—Machine without the Optional
Eductor Kit
If your machine has the optional eductor kit, skip to
the Lower Sprayer Supply Hose—Machines with the Optional
Eductor Kit (page 36).
1. Align the 90° flanged elbow of the sprayer supply
hose—2.5 x 73 cm (1 x 28-7/8 inches) with a
gasket—25 x 35 mm (1 x 1-3/8 inches) to the flange of
the filter head (Figure
34
Installing
70).