Toro Multi Pro 41240 Operator's Manual page 36

operator's seat. It allows you to start or stop the spray
operation. Press the switch to enable or disable the
spray system.
Left, Center, and Right Section
Switches
The left, center, and right section switches are located
on the control panel (Figure
forward to turn the corresponding section on and
rearward to turn them off. When the switch is turned
on, a light on the switch illuminates. These switches
affect the spray system only when the master section
switch is on.
Application-Rate Switch
The application-rate switch is located on the left
side of the control panel
hold the switch upward to increase the spray system
application rate, or press and hold it downward to
decrease application rate.
Boom-Section Lift Switches
The boom-section lift switches are located on the
control panel and are used to raise the outer boom
sections.
Sprayer-Mode Switch (HDX-Auto
Model)
Use the sprayer-mode switch to select between the
following spraying methods:
•
Use the manual mode when you want to manually
control the sprayer application rate.
•
Use the automatic mode when you want the
computer to control sprayer application rate with
setting you enter in the InfoCenter.
51). Toggle each switch
(Figure 51). Press and
1. InfoCenter console
2. Sprayer-mode switch
Regulating (Rate Control) Valve
The regulating valve located behind the tank
53), The regulating valve controls the amount of fluid
that is routed to the section valves or the rate return
to the tank.
1. Regulating (rate control)
valve
2. Agitation valve
3. Master-boom valve
36
Figure 52
3. Automatic mode
(sprayer-mode switch
position)
4. Manual mode
(sprayer-mode switch
position)
Figure 53
4. Flow meter
5. Section valves
g028486
(Figure
g028483