Installing The Control Console And Electrical Harness; Knob; J-Clips; Bolt (1/4 X 3/4 Inch) - Toro Multi Pro WM 41240 Operator's Manual

Figure 12
1. Existing speed sensor plugs
10. Use lift cylinders lower the tank to the frame.
11. Check the alignment of the tank skid and the vehicle
frame.
12. Use the access panels on both sides of the tank skid to
check for pinching of any hoses or wiring (Figure 13).
1
2
3
Figure 13
1. Access panel door
2. Bolt (1/2 x 1-1/2 inches)
Important: If any hoses or wiring on the tank skid
assembly are pinched or bent, raise the assembly
up, adjust its positioning, and tie the items back.
13. Attach the pump drive.
G022355
3. locknut (1/2 inch)
1. Rubber cowling
2. PTO drive shaft
•
Pull rearward on the rubber cowling of the front of
the PTO drive shaft (Figure 14).
•
Install the drive shaft onto the PTO output shaft
(Figure 14).
Important: Verify that the PTO shaft is secured
by making sure that the locking balls are seated in
the groove of the output shaft.
14. Line up the front mounting brackets with the
hold-down brackets installed previously.
15. Secure the tank skid assembly to the frame with a bolt
(1/2 x 1-1/2 inches) and a locknut (1/2 inch) as shown
in Figure 13.
7
Installing the Control Console
and Electrical Harness
Parts needed for this procedure:
1

Knob

3

J-clips

1

Bolt (1/4 x 3/4 inch)

1

Flange nut (1/4 inch)

1 Fuse decal (127–3966)
Procedure
The control box is stored on the console storage bracket on
the front right tank strap.
1. Remove the hair pin securing the control console to
the storage bracket.
2. Install the control console onto the control mounting
bracket using the previously removed hairpin.
16
Figure 14
3. PTO output shaft