Cleaning The Pressure Filter - Toro Multi Pro 41240 Operator's Manual

1. Screen vane
5. Clean the suction filter with clean water.
Important:
Replace the filter if it is damaged
or cannot be cleaned.
6. Insert the suction filter into the filter housing until
the filter is fully seated.
7. Align the hose and hose fitting to the filter
housing at the top of the tank, and secure fitting
and housing with the retainer that you removed
in step 2.

Cleaning the Pressure Filter

Service Interval: Before each use or daily—Clean
the pressure filter. Clean the
pressure filter (more often when
using wettable powders).
1. Park the machine on a level surface, engage the
parking brake, shut off the sprayer pump, shut
off the engine, and remove the key.
2. Align a drain pan under the pressure filter
(Figure 96).
Figure 95
2. Suction strainer
g033578
1. Filter head
2. Gasket (bowl)
3. Filter element
3. Rotate the drain cap counterclockwise and
remove it from the bowl of the pressure filter
(Figure 96).
Note:
Allow the bowl to drain completely.
4. Rotate the bowl counterclockwise and remove
the filter head
5. Remove the pressure filter element
6. Clean the pressure filter element with clean
water.
Important:
or cannot be cleaned.
7. Check the gasket for the drain plug (located
inside the bowl) and the gasket for bowl (located
inside the filter head) for damage and wear
(Figure 96).
Important:
gaskets for the plug, bowl, or both.
8. Install the pressure filter element into the filter
head (Figure
Note:
Ensure that the filter element is firmly
seated into the filter head.
9. Install the bowl onto the filter head, and tighten
by hand
10. Assemble the drain cap onto the fitting at the
bottom of the bowl, and tighten the cap by hand
(Figure 96).
64
Figure 96
4. Gasket (drain plug)
5. Drain cap
6. Bowl
(Figure 96).
Replace the filter if it is damaged
Replace any damaged or worn
96).
(Figure 96).
g033582
(Figure 96).