Table of Contents
Advertisement
throttle lock; refer to operation instructions
for your Workman hand throttle kit.
Performing a Catch Test
1.
Set all 3 section switches and the master-section
switch to the O
N
2.
Prepare to perform a catch test using the
graduated container.
3.
Start at 2.75 bar (40 psi) and use the
application-rate switch to adjust the spray
pressure so that a catch test yields the amounts
listed in the table that follows.
Note:
Collect 3 samples at 15 seconds each
and average the quantities of water collected.
Nozzle
Milliliters collected in
Color
15 seconds
Yellow
189
Red
378
Brown
473
567
Gray
White
757
Blue
946
Green
1,419
4.
Once the catch test has yielded the amounts
listed in the table above, set the supervisor
rate-lockout switch to the L
5.
Turn the master-section switch to the O
position.
Setting the InfoCenter
1.
On the InfoCenter, navigate to the Calibration
menu and select F
Note:
Selecting the Home Screen icon at any
time cancels calibrations.
A.
Press the center selection button on the
InfoCenter twice to access the menus.
B.
Enter the calibration menu by pressing the
right selection button on the InfoCenter.
C.
Select F
LOW
and press the right selection button on the
InfoCenter.
D.
In the next screen, enter the known quantity
of water that will be sprayed out of the
sections for the calibration procedure; refer
to the chart below.
E.
Press the right selection button on the
InfoCenter.
2.
Using the plus (+) and minus (-) symbols, enter
the flow volume according to the table below.
position.
Ounces collected in
15 seconds
6.4
12.8
16.0
19.2
25.6
32.0
48.0
position.
OCK
C
as follows:
LOW
AL
C
by highlighting F
AL
LOW
Nozzle Color
Yellow
Red
Brown
Gray
White
Blue
Green
3.
Turn on the master-section switch for 5 minutes.
Note:
displays the quantity of fluid that it is counting.
4.
After spraying for 5 minutes, select the
checkmark by pressing the center button on the
InfoCenter.
Note:
during the calibration process do not match
the known quantity of water entered into the
InfoCenter.
5.
Shut off the master-section switch and select
the checkmark by pressing the center button on
the InfoCenter.
Note:
Calibrating the Sprayer
Speed
FF
1.
Ensure that the sprayer tank is filled with water.
2.
On an open, flat area, mark off a distance
between 45 to 152 m (150 to 500 ft).
Note:
results.
3.
Start the engine and drive to the start of the
marked-off distance.
Note:
starting line for the most accurate measurement.
4.
On the InfoCenter, navigate to the Calibration
C
AL
menu and select Speed Calibration.
Note:
time cancels the calibration.
5.
Select the Next arrow (→) on the InfoCenter.
6.
Using the plus (+) and minus (-) symbols, enter
the marked-off distance into the InfoCenter.
7.
Perform one of the following:
•
For HD-Series Models with a manual
transmission—shift the machine into first
54
Liters
42
83
106
125
167
208
314
As the machine sprays, the InfoCenter
It is acceptable if the gallons displayed
Calibration is now complete.
Mark off 152 m (500 ft) for more accurate
Align the center of the front tires with the
Selecting the Home Screen icon at any
US Gallons
11
22
28
33
44
55
83
Advertisement
Chapters
Table of Contents
