Toro Multi Pro 41240 Operator's Manual page 52

Filling the Tanks
Filling the Freshwater Tank
Important:
Do not use reclaimed water (gray
water) in the freshwater tank.
Note:
The freshwater tank is used to supply a source
of fresh water for you to wash chemicals off your
skin, eyes, or other surfaces in the case of accidental
exposure.
Always fill the freshwater tank with clean water before
handling or mixing any chemicals.
The freshwater tank is located on the ROPS, behind
the passenger seat (Figure
fresh water for you to wash chemicals from your skin,
eyes, or other surfaces in case of accidental exposure.
•
To fill the tank, unscrew the cap on the top of the
tank and fill the tank with fresh water. Replace
the cap.
•
To open the freshwater tank spigot, turn the lever
on the spigot.
Figure 82
1. Filler cap
2. Freshwater tank
Filling the Spray Tank
Install the Chemical Pre-Mix Kit for optimal mixing and
exterior tank cleanliness.
Important:
Whenever possible, do not use
reclaimed water (gray water) in the spray tank.
82). It supplies a source of
3. Spigot
Important:
Ensure that the chemicals you use
are compatible for use with Viton
manufacturer's label; it should indicate if it is
not compatible). Using a chemical that is not
compatible with Viton
the sprayer, causing leaks.
Important:
After filling the tank for the first time,
check the tank straps for any play. Tighten them
as necessary.
1. Purge the spray system of spray-system
conditioner by running the sections.
2. Park the machine on a level surface, move the
range selector to the neutral position, engage
the parking brake, shut off the engine, and
remove the key.
3. Ensure that the tank drain valve is closed.
4. Determine the amount of water needed to mix
the amount of chemical you need as prescribed
by the chemical manufacturer.
5. Open the tank cover on the spray tank.
Note:
The tank lid is located at the center of the
top of the tank. To open it, turn the front half of
the cover counterclockwise and swing it open.
You can remove the strainer inside for cleaning.
To seal the tank, close the cover and rotate the
front half clockwise.
6. Add 3/4 of the required water to the spray tank
using the anti-siphon fill receptacle.
Important:
the spray tank. Do not pour concentrate into
an empty tank.
g210327
7. Start the engine, engage the PTO, and set the
hand throttle if equipped.
8. Turn the agitation switch O
9. Add the proper amount of chemical concentrate
to the tank, as directed by the chemical
manufacturer.
52
TM (see the
TM degrades the O-rings in
Always use fresh, clean water in
Figure 83
position.
N
g239037