Toro Multi Pro 41240 Operator's Manual page 14

4
Installing the Tank Skid
Parts needed for this procedure:
1 Tank and skid assembly
2 Clevis pins
2 Tapered clevis pin
2 Hairpins
4 Lynch pins
2 Bolt (1/2 x 1-1/2 inches)
2 Nuts (1/2 inch)
Procedure
DANGER
The sprayer tank assembly represents a
stored energy hazard. If not properly retained
when installing or removing the assembly,
it can move or fall and injure you or other
bystanders.
Use straps and an overhead lift to support
the sprayer tank assembly during installation,
removal, or any maintenance whenever you
remove retaining fasteners.
1. Using a lift, raise the tank skid assembly
8) and position it over the vehicle frame with the
pump and valve assemblies facing rearward.
Note:
Have another person help you perform
the following steps.
1. Rear lift point
Figure 8
2. Front lift point
2. Slowly lower the tank skid onto the frame of the
machine.
3. Extend the lift cylinders to the brackets on the
tank skid, and align the cylinder fittings with the
holes in the tank skid brackets
1. Hairpin
2. Clevis pin
4. Secure the tank skid to the lift cylinders with
the clevis pins and hairpins at both sides of the
machine.
5. Line up the holes in the pivot lugs at the rear
of the tank skid assembly with the holes in the
bed pivot tube at the end of the vehicle frame
(Figure
(Figure
1. Tapered clevis pin
6. Install a tapered clevis pin and 2 lynch pins to
the pivot lug to secure the tank assembly to the
frame
7. Extend the lift cylinders to raise the tank and
support its weight.
Note:
g023738
lifting equipment.
8. Remove the bed support from the storage
brackets on back of the ROPS panel
14
Figure 9
3. Lift cylinders
10).
Figure 10
2. Lynch pin
(Figure 10).
Disconnect the tank assembly from the
(Figure 9).
g022353
g022354
(Figure 11).