Installing The Electrical Harness; Fuse Block; Fuse; Screw, #10-24 X 3/4 Inch - Toro 41229 Operator's Manual

4. Install the geartooth sensor using the screw
(M6 x 1.00 x 12) and spring washer (M6) as shown in
figure 5.
5. Install the PTO kit. Refer the Installation Instructions
for more information.
Installing the Electrical
Harness
1. Remove the screws holding the front hood to the
frame. Remove the hood to access the electrical
wiring.
2. Attach the electrical harness to the fuse block by
joining the wires in the harness to the corresponding
wire connectors in the back of the fuse block (Fig. 6).
3
1
4
6
Figure 6
1. Wiring harness
2. New fuse block
3. Red/black wire
4. Red/white wire
5. Red wire
3. Connect the black ground wire to the existing 1/4 inch
bolt on the vehicle frame, using the star washer
(Fig. 7).
2
7
8
9
5
10
m–7218
6. Black ground wire
7. Foam marker fuse slot
8. Boom lift fuse slot
9. Spray system fuse slot
10. Open slot, not used
4. Install the fuse block and harness to the frame along
side the existing fuse block, using the two screws
(#10-24 x 3/4 inch), two washers (7/32 inch), and two
locknuts (#10-24) as shown in figure 7.
5. Install the 10 amp fuse to the spray system fuse slot
and attach new fuse block decal (Fig. 7).
5
3 4
2
8
9

1. Fuse block

2. Fuse, 10 amp
3. Screws, #10-24 x 3/4 inch
4. Washers, 7/32 inch
5. Lock nut, #10-24 inch)
6. Route the wiring harness through the opening in the
floor, under the seat base, and rearward along with the
existing wiring.
14
1
6
m–7151
Figure 7
6. Existing decal
7. New fuse block decal
8. Ground wire, black
9. Star washer and bolt
7